LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1568 (Automatic Transmission - 6L45/6L50/6L80/6L90 - Repair Instructions - On Vehicle) >> Repair Instructions - On Vehicle >> Propeller Shaft Front Slip Yoke Oil Seal Replacement (Two Wheel Drive)

Propeller Shaft Front Slip Yoke Oil Seal Replacement (Two Wheel Drive)

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Fig 1: Propeller Shaft Front Slip Yoke Oil Seal (Two Wheel Drive)
GM1822785Courtesy of GENERAL MOTORS CORP.
Callout Component Name

Preliminary Procedures

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the propeller shaft. Refer to One-Piece Propeller Shaft Replacement or Two-Piece Propeller Shaft Replacement .
1 Propeller Shaft Front Slip Yoke Oil Seal

Special Tools

  • DT-48021  Seal Installer (6L90). See Special Tools .
  • J 8092  Driver Handle (6L90)
  • J 38869  Output Shaft Seal Installer (6L80)
  • J 45000  Seal Remover