LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1410 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L (5 Of 5)) >> Repair Instructions - Off Vehicle (3 Of 3) >> Engine Coolant Air Bleed Pipe and Hole Cover Installation (RPO LY2/LY6/L9H)

Engine Coolant Air Bleed Pipe and Hole Cover Installation (RPO LY2/LY6/L9H)

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Coolant Air Bleed Pipe Seal
    GM1552485Courtesy of GENERAL MOTORS CORP.
    NOTE: Position the gasket O-ring seal (308) onto the nipple portion of the pipe.
  1. Install the seals onto the engine coolant air bleed pipe and covers.
    2. Fig 2: View Of Engine Coolant Air Bleed Pipe
    GM1403313Courtesy of GENERAL MOTORS CORP.
  2. Install the pipe (307) and seals (308).
    3. CAUTION: Refer to Fastener Caution .
  3. Install the bolts (309) and tighten to 12 N.m (106 lb in).
    4. Fig 3: Identifying Coolant Air Bleed Cover Bolts
    GM1403314Courtesy of GENERAL MOTORS CORP.
  4. Install the covers (313) and seals (308).
  5. Install the bolts (312) and tighten to 12 N.m (106 lb in).
scientia non olet · About LEMON Manuals