Engine Front Cover Removal (RPO LY2/LH6/LMG/LY5/LC9)
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the front cover bolts (1).
- Remove the front cover (2) and gasket (3).
- Discard the front cover gasket.
- Remove the oil seal (4).
- Remove the bolts (1, 6), camshaft position (CMP) sensor (2), and wire harness (5).
- Remove the O-ring (3) from the sensor, as required.