LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1376 (Engine Controls And Fuel - 4.8L, 5.3L, 6.0L, 6.2L - DTC P0230 To DTC P0690) >> DTC P0324, P0325, P0326, P0327, P0328, P0330, P0332, or P0333 >> Circuit/System Testing >> P0325, P0327, P0328, P0330, P0332, P0333

P0325, P0327, P0328, P0330, P0332, P0333

WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition ON, engine OFF.
  2. Disconnect the appropriate KS harness connector.
  3. Measure for 2-3 volts between each of the following circuits and ground on the ECM side of the harness connector:
    • The KS signal circuit, terminal A
    • The KS signal circuit, terminal B
    • If less than the specified range, test the circuits for a short to ground or an open/high resistance. If the circuits test normal, replace the ECM.
    • If greater than the specified range, test the circuits for a short to voltage. If the circuits test normal, replace the ECM.
  4. If all circuits test normal, replace the KS.
scientia non olet · About LEMON Manuals