Removal Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Remove the plastic caps from the quick connect fittings by pulling the caps back along the pipe before installation.

Fig 1: View Of J 41623-B & Generator Cooling Inlet Pipe

GM1195053

Courtesy of GENERAL MOTORS CORP.

Install the J 41623-B onto the transmission oil cooler (TOC) pipe, or use the J 28585

Fig 2: Sliding J 41623-B Toward TOC Pipe Fitting

GM1195054

Courtesy of GENERAL MOTORS CORP.

Slide the J 41623-B toward the TOC pipe fitting, or use the J 28585

Fig 3: Rotating J 41623-B On Coolant Pipe

GM1195056

Courtesy of GENERAL MOTORS CORP.

NOTE: Rotate the J 41623-B to engage the TOC pipe fitting's retainer slots.
The J 41623-B should be nearly flush with the fitting.

Connect the J 41623-B onto the TOC pipe fitting.

Fig 4: Rotating J 41623-B Until Retainer Clip Rises Above Fitting Retainer Seat

GM1195059

Courtesy of GENERAL MOTORS CORP.

Rotate the J 41623-B or use the J 28585 until the retainer clip (1) rises above the fitting retainer seat.

Fig 5: View Of J 41623-B & Generator Cooling Inlet Pipe

GM1195062

Courtesy of GENERAL MOTORS CORP.

Pull back on the TOC pipe to disengage the pipe from the TOC pipe fitting.
Remove the J 41623-B or the J 28585 from the TOC pipe.