LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1356 (Automatic Transmission - 4L60-E - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - Off Vehicle >> Turbine Shaft Seal Installation >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2009 GMC Sierra and 2009 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Turbine Shaft Oil Seal Rings
    GM1601754Courtesy of GENERAL MOTORS CORP.
  1. Use the J 36418-1B:  seal installer (1) in order to install the four turbine shaft oil seal rings (619).
  2. Resize oil seal rings (619) after installation:
    1. Place J 36418-2A:  seal sizer (2) over the turbine shaft oil seal rings (619) and seat against input housing.
    2. Remove J 36418-2A:  seal sizer (2).
    3. Turn J 36418-2A:  seal sizer (2) upside down and place over the turbine shaft oil seal ring (619).
    4. Seat against input housing.
    5. Leave J 36418-2A:  seal sizer (2) in place over the turbine shaft oil seal rings (619) until the reverse input clutch housing is installed.
scientia non olet · About LEMON Manuals