2-6 Clutch Plates Installation
WARNING: This page is about a different car, the 2009 GMC Sierra, 2009 GMC Cab & Chassis Sierra, 2009 Chevrolet Silverado, and 2009 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
2-6 Clutch Plates Installation
| Callout | Component Name |
|---|---|
| 1 | 2-6 Clutch (Waved) Plate |
| 2 | 2-6 Clutch Plates (Qty: 6) Tip: Alternate between steel and fiber clutch plates. |
| 3 | 2-6 Clutch Plate Assembly (Qty: 6) Tip: Alternate between steel and fiber clutch plates. |
| 4 | 2-6 Clutch Backing Plate |
| 5 | 2-6 Clutch Backing Plate Retaining Ring
CAUTION:
When installed, the open end of the snap ring must orient away from the slotted and scalloped areas of the center support assembly. Ideal orientation location should be at the 3 o'clock or 9 o'clock position of the center support, when facing the pan side of the case. Orienting the snap ring opening with either the scalloped or slotted areas of the center support may cause transmission damage. Procedure: Be sure to install the retaining ring gap at the 9 o'clock or 3 o'clock position, as indicated by the arrows. |
| 6 | 2-6 Clutch Apply Passage Tip: Apply air to verify proper installation of all 2-6 clutch components. |