Rear Output Shaft Seal and Bushing Removal

WARNING: This page is about a different car, the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Rear Output Shaft Seal and Bushing

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Transfer Case Rear Output Shaft Seal NOTE: Refer to Transfer Case Seal Removal Notice .
2	Transfer Case Rear Output Shaft Bushing Tip: Only remove the bushing if faulty. Refer to Transfer Case Rear Half Cleaning and Inspection . Follow the steps below for use of the J 45380 . Install the finger section of the J 45380 in front of the bushing. Install the tube and forcing screw assembly into the finger section. Ensure the forcing screw is backed out. Using a wrench on the forcing screw, remove the bushing. Special Tools: J 45380 Transfer Case Rear Bushing Remover and Installer

Callout

Component Name

Transfer Case Rear Output Shaft Seal

NOTE: Refer to Transfer Case Seal Removal Notice .

Transfer Case Rear Output Shaft Bushing
Tip:

Only remove the bushing if faulty. Refer to Transfer Case Rear Half Cleaning and Inspection .
Follow the steps below for use of the J 45380 .
1. Install the finger section of the J 45380 in front of the bushing.
2. Install the tube and forcing screw assembly into the finger section. Ensure the forcing screw is backed out.
3. Using a wrench on the forcing screw, remove the bushing.

Special Tools:
J 45380 Transfer Case Rear Bushing Remover and Installer