LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1220 (Engine Mechanical - 4.8L, 5.3L, 6.0L Or 6.2L (2 Of 5)) >> On-Vehicle Repair Instructions (1 Of 2) >> Camshaft Position Actuator Solenoid Valve Replacement >> Removal Procedure

Removal Procedure

WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2008 GMC Yukon XL, 2008 GMC Yukon, 2008 Chevrolet Tahoe, 2008 Chevrolet Suburban, and 2008 Chevrolet Avalanche. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Special Tool & Bolts
    GM1658136Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the J 42386-A  (1) and bolts. See Special Tools . Use 1 M10 - 1.5 x 120 mm and 1 M10 - 1.5 x 45 mm bolt for proper tool operation.

    Tighten:  Tighten the J 42386-A  bolts to 50 N. See Special Tools .m (37 lb ft).

  2. Remove the camshaft position (CMP) actuator magnet. Refer to Camshaft Position Actuator Magnet Replacement .
    3. Fig 2: View Of CMP Actuator Solenoid Valve
    GM1670622Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Camshaft Position Actuator Removal and Installation Caution .
  3. Remove the CMP actuator solenoid valve (234).
  4. Discard the solenoid valve.
scientia non olet · About LEMON Manuals