LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1163 (Engine Mechanical - 3.6L (5 Of 6)) >> Off-Vehicle Repair Instructions (3 Of 4) >> Intake Manifold Disassemble (LY7) >> Upper to Lower Intake Manifold Disassemble Procedure

Upper to Lower Intake Manifold Disassemble Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Upper-To-Lower Intake Manifold Bolts
    GM1888137Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not reuse the upper-to-lower intake manifold gasket and the intake manifold-to-cylinder head sealing gaskets.
  1. Remove the upper-to-lower intake manifold bolts.
    2. Fig 2: View Of Injector Harness Bracket Bolt
    GM1318829Courtesy of GENERAL MOTORS CORP.
  2. Remove the fuel injector wiring harness bracket bolt from the upper intake manifold.
    3. Fig 3: View of Upper Intake Manifold And Lower Intake Manifold
    GM1888141Courtesy of GENERAL MOTORS CORP.
  3. Remove the upper intake manifold from the lower intake manifold.
    4. Fig 4: View of Upper-To-Lower Intake Manifold Gaskets
    GM1888145Courtesy of GENERAL MOTORS CORP.
  4. Remove and discard the upper-to-lower intake manifold gaskets.
scientia non olet · About LEMON Manuals