LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1163 (Engine Mechanical - 3.6L (5 Of 6)) >> Off-Vehicle Repair Instructions (3 Of 4) >> Intake Manifold Assemble (LY7) >> Upper Intake Manifold Assemble Procedure

Upper Intake Manifold Assemble Procedure

WARNING: This page is about a different car, the 2008 Cadillac CTS. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Sight Shield Grommet
    GM1888154Courtesy of GENERAL MOTORS CORP.
  1. Install the sight shield grommet.
    2. Fig 2: Identify Sight Shield Ball Studs
    GM1888153Courtesy of GENERAL MOTORS CORP.
  2. Install the sight shield ball studs.

    Tighten:  Tighten the sight shield ball studs to 7 N.m (62 lb in).

    3. Fig 3: View of Communicator Valve
    GM1888151Courtesy of GENERAL MOTORS CORP.
  3. Install the communicator valve.
  4. Install the communicator valve bolts.

    Tighten:  Tighten the communicator valve bolts to 10 N.m (89 lb in).

    5. Fig 4: Identifying Barometric Pressure (Baro) Sensor
    GM1888150Courtesy of GENERAL MOTORS CORP.
  5. Install the barometric pressure (BARO) sensor.
  6. Install the BARO sensor bolt.

    Tighten:  Tighten the BARO sensor bolt to 10 N.m (89 lb in).

    7. Fig 5: View Of Throttle Body Assembly
    GM1888148Courtesy of GENERAL MOTORS CORP.
  7. Install the NEW throttle body gasket.
  8. Install the throttle body.
  9. Install the throttle body bolts.

    Tighten:  Tighten the throttle body bolts to 10 N.m (89 lb in).

scientia non olet · About LEMON Manuals