LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1080 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L (5 Of 5)) >> Off-Vehicle Repair Information (3 Of 3) >> Engine Coolant Air Bleed Pipe and Hole Cover Installation (RPO LH6/LMG/LY5/LC9/L76)

Engine Coolant Air Bleed Pipe and Hole Cover Installation (RPO LH6/LMG/LY5/LC9/L76)

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Coolant Air Bleed Pipe Seal
    GM1552485Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Position the O-ring seal onto the nipple portion of the pipe.
  1. Install the seals (308) onto the engine coolant air bleed pipe and covers.
    2. Fig 2: Engine Coolant Air Bleed Pipe
    GM1401993Courtesy of GENERAL MOTORS CORP.
  2. Install the pipe (307) and seals (308).
    3. NOTE: Refer to Fastener Notice .
  3. Install the bolts (309).

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

    4. Fig 3: Engine Coolant Air Bleed Cover Bolts
    GM1402001Courtesy of GENERAL MOTORS CORP.
  4. Install the covers (313) and seals (308).
  5. Install the bolts (312).

    Tighten:  Tighten the cover bolts to 12 N.m (106 lb in).

scientia non olet · About LEMON Manuals