LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1079 (Engine Mechanical - 6.6L (3 Of 5)) >> Off-Vehicle Repair Instructions (2 Of 4) >> Engine Flywheel Removal (Manual Transmission) >> Removal

Engine Flywheel Removal (Manual Transmission): Removal

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Locking Flywheel Using J 44643
    GM660308Courtesy of GENERAL MOTORS CORP.
  1. Install the J 44643  to the starter opening in order to hold the flywheel. See Special Tools .
    2. Fig 2: Accessing Flywheel To Crankshaft Bolts
    GM688118Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: Do not use the clutch pressure plate bolts. Use a bolt of the correct thread and a length that protrudes enough to use a pry bar.
  2. Install two bolts into the clutch pressure plate mounting holes 180 degrees apart.
  3. Using a long pry bar, turn the secondary ring of the dual mass flywheel clockwise until the flywheel mounting bolts can be accessed. It may require to turn the secondary ring past the bolt holes in order to compensate the spring tension.
    4. Fig 3: View Of Flywheel & Mounting Bolts (Manual)
    GM679414Courtesy of GENERAL MOTORS CORP.
  4. Remove the flywheel mounting bolts and discard.
  5. Remove the J 44643  . See Special Tools .
    6. CAUTION: When removing, handling or installing this component wear protective gloves. The sharp edges on the component may be very sharp and may cause injury.
  6. Remove the flywheel.
scientia non olet · About LEMON Manuals