LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1065 (Engine Mechanical - 4.3L) >> Repair Instructions - Off Vehicle >> Crankshaft Rear Oil Seal and Housing Removal

Crankshaft Rear Oil Seal and Housing Removal

WARNING: This page is about a different car, the 2008 GMC Sierra and 2008 Chevrolet Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Crankshaft Rear Oil Seal Notches
    GM31379Courtesy of GENERAL MOTORS CORP.
  1. Remove the crankshaft rear oil seal from the crankshaft rear oil seal housing.

    Insert a suitable tool into the access notches and then carefully pry the crankshaft rear oil seal from the crankshaft rear oil seal housing.

  2. Discard the crankshaft rear oil seal.
    3. Fig 2: View Of Crankshaft Rear Oil Seal Housing Nut & Bolts
    GM334317Courtesy of GENERAL MOTORS CORP.
  3. Remove the crankshaft rear oil seal housing nut and bolts.
  4. Remove the crankshaft rear oil seal housing.
    5. Fig 3: Identifying Crankshaft Rear Oil Seal Housing Gasket
    GM334319Courtesy of GENERAL MOTORS CORP.
  5. Remove the crankshaft rear oil seal housing gasket.
  6. Discard the crankshaft rear oil seal housing gasket.
    7. Fig 4: Locating Crankshaft Rear Oil Seal Housing Retainer Stud
    GM334326Courtesy of GENERAL MOTORS CORP.
  7. Remove the crankshaft rear oil seal housing retainer stud from the engine block.
scientia non olet · About LEMON Manuals