Shift Detent Plunger Assembly, Shift Detent Lever, Input Shaft, and Planetary Assembly Removal

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Shift Detent Plunger Assembly, Shift Detent Lever, Input Shaft, and Planetary Assembly

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Transfer Case Shift Detent Plunger Plug
2	Transfer Case Shift Detent Plunger Plug Seal
3	Transfer Case Shift Detent Spring
4	Transfer Case Shift Detent Plunger
5	Transfer Case Shift Detent Lever Assembly
6	Transfer Case Shift Lever Seal
7	Transfer Case Input Shaft Seal
8	Transfer Case Input Shaft Bearing Outer Retaining Ring CAUTION: Do not rotate the transfer case while the retaining ring is removed. Rotating the transfer case while the retaining ring is removed, may cause the input shaft/planetary assembly to fall from the transfer case, resulting in personal injury.
9	Transfer Case Input Shaft/Planetary Assembly
10	Transfer Case High/Low Planetary Carrier Retaining Ring
11	Transfer Case High/Low Locking Plate
12	Transfer Case Planetary Carrier Sun Gear Thrust Washer
13	Transfer Case Input Shaft
14	Transfer Case Input Shaft Pilot Bearing Assembly Tip: Only remove the bearing if faulty. Refer to Front Output Shaft and Input Shaft Cleaning and Inspection .
15	Transfer Case Planetary Carrier Sun Gear Thrust Washer
16	Transfer Case High/Low Planetary Carrier Assembly
17	Transfer Case Input Shaft Inner Retaining Ring
18	Transfer Case Input Shaft Bearing Assembly