LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1037 (Automatic Transmission - ALLISON - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> On-Vehicle Repair Information >> Transmission Fluid Filler Tube and Seal Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Fill Tube Plug & Seal
    GM658984Courtesy of GENERAL MOTORS CORP.
  1. Install a new fill tube plug seal (2) into the main housing.
  2. Align the tab on the fill tube plug (1) with the tang on the main housing.
  3. Install the fill tube plug (1). Press the plug into the seal (2) until the tab on the fill tube plug locks into place in the notch on the main housing.
    4. Fig 2: Fill Tube Nuts
    GM702779Courtesy of GENERAL MOTORS CORP.
  4. Install a NEW fill tube seal.
  5. Install the fill tube. Ensure that the fill tube bracket is positioned properly on the studs.
    NOTE: Refer to Fastener Notice .
  6. Install the fill tube nuts.

    Tighten:  Tighten the nuts to 18 N.m (13 lb ft).

  7. Install the heat shield. Refer to Transmission Heat Shield Replacement .
  8. Lower the vehicle.
  9. Fill the transmission to the proper level with approved fluid.
scientia non olet · About LEMON Manuals