LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1037 (Automatic Transmission - ALLISON - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Information >> Transmission End Play Measurement >> Measurement

Transmission End Play Measurement: Measurement

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Rear Bearing
    GM1235600Courtesy of GENERAL MOTORS CORP.
  1. Using J 24446  (1), install the ball bearing (2) until the bearing seats. See Special Tools .
  2. Fig 2: Locating Transmission Retaining Ring
    GM1235598Courtesy of GENERAL MOTORS CORP.
  3. Align the retaining ring (1) so that the beveled edge is facing up.
  4. Install the retaining ring (1).
  5. Fig 3: View Of Dial Indicator Set On Transmission Case
    GM1217571Courtesy of GENERAL MOTORS CORP.
  6. Position the transmission case so that the front is facing up.
  7. Assemble the following tools and install them onto the torque converter housing as shown.
    • J 5959-3 extension (1)
    • J 5959-1 dial indicator (2)
    • J 5959-2 base (3)
    • J 5959-7 clamp (4)
  8. Zero the dial indicator (2).
  9. Lift the rear of the 1-2-3-4, 4-5-6 clutch housing with a screwdriver through the power take-off (PTO) hole in the transmission case.
  10. Note the end play measured on the dial indicator.

    Specification:  The transmission end play must be 0.279-1.549 mm (0.011-0.061 in).

  11. If the end play is not within the specification, a different selective spacer must be installed.
  12. Remove the special tools from the transmission.
  13. Remove the retaining ring and the ball bearing assembly.
  14. Repeat the measurement and calculation to determine the correct selective spacer.