LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1037 (Automatic Transmission - ALLISON - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Off-Vehicle Repair Information >> Low and Reverse Clutch Housing Retaining Ring Replacement

Low and Reverse Clutch Housing Retaining Ring Replacement

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Low and Reverse Clutch Housing Retaining Ring
    GM1235405Courtesy of GENERAL MOTORS CORP.
    IMPORTANT: DO NOT replace the retaining ring in the low and reverse clutch housing unless:
    • The retaining ring is damaged.
    • The low and reverse clutch housing is to be replaced.
  1. Position the low and reverse clutch housing (2) on the worktable so that the inside of the cover is facing down.
  2. Remove retaining ring (1).
  3. Install a new retaining ring (1).
  4. Make sure the retaining ring is seated.
scientia non olet · About LEMON Manuals