Rear Output Shaft Assembly Disassemble

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Rear Output Shaft Assembly Components

Courtesy of GENERAL MOTORS CORP.

Callout	Component Name
1	Transfer Case Rear Output Shaft Rear Bearing Retaining Ring
2	Transfer Case Rear Output Shaft Rear Bearing Assembly Tip: Use an arbor press or suitable puller to remove the bearing from the rear output shaft.
3	Transfer Case Rear Output Shaft Rear Bearing Retaining Ring
4	Transfer Case Rear Output Shaft Speed Reluctor Wheel
5	Transfer Case Oil Pump Assembly
6	Transfer Case Front Output Shaft Drive Sprocket Retaining Ring
7	Transfer Case Front Output Shaft Drive Sprocket Spacer - Rear
8	Transfer Case Front Output Shaft Drive Sprocket
9	Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly (Qty: 2) Tip: Only remove the bearing if faulty. Refer to Drive Chain, Drive Sprocket, and Driven Sprocket Cleaning and Inspection .
10	Transfer Case Two/Four Wheel Drive Synchronizer Blocking - Inner - Ring
11	Transfer Case Two/Four Wheel Drive Synchronizer Blocking - Outer - Ring
12	Transfer Case Two/Four Wheel Drive Synchronizer Assembly
13	Transfer Case Two/Four Wheel Drive Synchronizer Sleeve
14	Transfer Case Two/Four Wheel Drive Synchronizer Insert (Qty: 3)
15	Transfer Case Two/Four Wheel Drive Synchronizer Hub
16	Transfer Case Rear Output Shaft