Front Output Shaft Drive Sprocket Bearing Replacement
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
Courtesy of GENERAL MOTORS CORP.
| Callout |
Component Name |
|
Preliminary Procedure
- Using the J 35512
and an arbor press, remove the bearing assemblies from the drive sprocket.
- Ensure the bearings are installed squarely into the drive sprocket bore.
|
| 1 |
Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Front
Tip:
- Install the bearing using the long side of the DT-48211
.
- Ensure the flat edge of the bearing is facing upward.
- Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket.
Special Tools
- DT-48211
Drive Sprocket Bearing Installer
- J 8092
Driver Handle
- J 35512
Inner Pinion Bearing Installer
|
| 2 |
Transfer Case Front Output Shaft Drive Sprocket Bearing Assembly - Rear
Tip:
- Install the bearing using the short side of the DT-48211
.
- Ensure the flat edge of the bearing is facing upward.
- Using an arbor press or hammer, install the bearing until the tool bottoms on the drive sprocket.
Special Tools
- DT-48211
Drive Sprocket Bearing Installer
- J 8092
Driver Handle
- J 35512
Inner Pinion Bearing Installer
|