Transfer Case Growl or Grinding Noise
WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
| Cause |
Correction |
DEFINITION: A faulty internal transfer case component that causes a growl or grinding noise in the transfer case while the vehicle is turning or in a four wheel drive mode. Review the Symptoms - Transfer Case and perform the necessary inspections. |
| High/low planetary carrier assembly |
- Inspect the high/low planetary carrier assembly for the following conditions:
- Replace the high/low planetary carrier assembly if any of the above conditions exist. Refer to Transfer Case Disassemble and Transfer Case Assemble .
|
| Input shaft |
- Inspect the input shaft in the planetary carrier assembly for excessive thrust end play.
- Inspect the input shaft teeth for the following conditions:
- Replace the input shaft if faulty. Refer to Transfer Case Disassemble and Transfer Case Assemble .
|
| Thrust washers |
- Inspect for missing or damaged input shaft thrust washers.
- Inspect the thrust washers for galling.
- Replace the thrust washers if faulty and the mating component if damaged. Refer to Transfer Case Disassemble and Transfer Case Assemble .
|
| High/low internal gear |
- Inspect the high/low internal gear teeth for the following conditions:
- Replace the front case half if the high/low internal gear is faulty. Refer to Transfer Case Disassemble and Transfer Case Assemble .
|