LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 1022 (Engine Mechanical - 4.8L, 5.3L, 6.0L, 6.2L, Or 7.0L (2 Of 5)) >> On-Vehicle Repair Information (1 Of 2) >> Engine Mount Replacement - Right Side (1500 LY2) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 GMC Sierra, 2008 GMC Cab & Chassis Sierra, 2008 Chevrolet Silverado, and 2008 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Mount
    GM1701802Courtesy of GENERAL MOTORS CORP.
  1. Position the engine mount to the engine.
    2. NOTE: Refer to Fastener Notice .
    Fig 2: View Of Engine Mount To Engine Bolts
    GM1701534Courtesy of GENERAL MOTORS CORP.
  2. Install the engine mount to engine bolts (1).

    Tighten: 50 N.m (37 lb ft) 

  3. Using the adjustable jack, lower the engine until the engine mount is sitting flush on the frame.
  4. Remove the adjustable jack from the engine block lifting tab (1).
  5. Partially lower the vehicle.
    6. Fig 3: View Of Engine Mount To Frame Bolts
    GM1701531Courtesy of GENERAL MOTORS CORP.
  6. Install the engine mount to frame bolts (1).

    Tighten: 65 N.m (48 lb ft)  Tighten the bolts starting with the middle bolt then either side bolt.

  7. Install the right wheelhouse liner. Refer to FRONT WHEELHOUSE LINER REPLACEMENT - RIGHT SIDE .
  8. Raise the vehicle.
  9. Install the knock sensor. Refer to KNOCK SENSOR 2 REPLACEMENT .
  10. Install the starter motor. Refer to Starter Motor Replacement .
  11. Install the right front differential carrier bracket. Tighten the front differential carrier mounting bracket bolts to 100 N.m (74 lb ft)  .
  12. Support and raise the differential carrier with a transmission jack.
  13. Install the right differential carrier mounting nuts and washers and tighten to 100 N.m (75 lb ft)  .
  14. Remove the transmission jack from the differential carrier.
  15. Install the front stabilizer shaft insulators. Refer to Stabilizer Shaft Insulator Replacement .
  16. Install the clip for the transmission cooler lines.
  17. Lower the vehicle.
  18. Install the upper intake manifold sight shield. Refer to Upper Intake Manifold Cover Replacement .
scientia non olet · About LEMON Manuals