LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, RWD >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> ENGINE MECHANICAL - 4.8L, 5.3L, AND 6.0L (2 Of 4) >> Off-Vehicle Repair Instructions (Part 1) >> Engine Flywheel Removal

Engine Flywheel Removal

    IMPORTANT: The flex plate does not use a locating pin for alignment and will not initially seat against the crankshaft flange or spacer, if applicable, but will be pulled onto the crankshaft by the bolts. This procedure requires a 3 stage tightening process.
    Fig 1: View Of Engine Flywheel & Bolt
    GM178458Courtesy of GENERAL MOTORS CORP.
  1. Remove the bolts.
  2. Remove the flex plate.
    3. Fig 2: View Of Bolts & Spacer
    GM642281Courtesy of GENERAL MOTORS CORP.
  3. Install 2 M11 x 1.5 mm bolts (1) into the threaded holes of the spacer, if applicable.
  4. Rotate the bolts clockwise to remove the spacer.
    5. Fig 3: View Of Spacer & Crankshaft Rear
    GM642276Courtesy of GENERAL MOTORS CORP.
  5. Remove the spacer from the rear of the crankshaft, if applicable.
scientia non olet · About LEMON Manuals