New Special Tools Required

J 41479-2A has been developed to install the rear oil seal on RPO HP2 equipped vehicles. See Special Tools .
J 45849 has been developed to remove the pilot bushing on RPO HP2 equipped vehicles when the crankshaft is replaced. See Special Tools .
J 45949 has been developed to install the pilot bushing on RPO HP2 equipped vehicles when the crankshaft has been replaced. See Special Tools .
J 46093 has been developed to hold the cranktrain stationary on RPO HP2 equipped vehicles to allow for the on-vehicle removal and installation of the crankshaft balancer. See Special Tools .
Refer to Special Tools .