Selective Snap Ring Table
WARNING: This page is about a different variant/trim than selected.
Selective Snap Ring Table
| Application | Specification | |
|---|---|---|
| Metric | English | |
| Countershaft Rear Bearing Retaining Ring | 1.80 mm | 0.0709 in |
| Countershaft Rear Bearing Retaining Ring | 1.90 mm | 0.0748 in |
| Countershaft Rear Bearing Retaining Ring | 2.00 mm | 0.0787 in |
| Countershaft Rear Bearing Retaining Ring | 2.10 mm | 0.0827 in |
| 4th/5th Gear Synchronizer Hub Retaining Ring | 2.00 mm | 0.0787 in |
| 4th/5th Gear Synchronizer Hub Retaining Ring | 2.05 mm | 0.0807 in |
| 4th/5th Gear Synchronizer Hub Retaining Ring | 2.10 mm | 0.0827 in |
| 4th/5th Gear Synchronizer Hub Retaining Ring | 2.15 mm | 0.0846 in |
| 4th/5th Gear Synchronizer Hub Retaining Ring | 2.20 mm | 0.0866 in |
| 4th/5th Gear Synchronizer Hub Retaining Ring | 2.25 mm | 0.0886 in |
| 4th/5th Gear Synchronizer Hub Retaining Ring | 2.30 mm | 0.0906 in |
| 4th/5th Gear Synchronizer Hub Retaining Ring | 2.35 mm | 0.0925 in |
| 4th/5th Gear Synchronizer Hub Retaining Ring | 2.40 mm | 0.0945 in |
| 4th/5th Gear Synchronizer Hub Retaining Ring | 2.45 mm | 0.0965 in |
| 4th/5th Gear Synchronizer Hub Retaining Ring | 2.50 mm | 0.0984 in |