Input Shaft Disassemble

Tools Required 

J 36513  Gear and Bearing Separator Plate

IMPORTANT:
• Only remove the bearings if replacing the bearings. Do not use the bearings again after removal.
• You must also replace the race for the bearing being replaced.
1. Inspect the bearing for damage or wear. Refer to Bearings and Spacers Cleaning and Inspection .
2. Using a hydraulic press and the J 36513  (1), remove the input shaft bearing.
   Fig 1: Using J 36513 To Remove Input Shaft Bearing

   Courtesy of GENERAL MOTORS CORP.
3. Remove the input shaft oil deflector using a suitable prying tool.
   Fig 2: Removing Input Shaft Oil Deflector

   Courtesy of GENERAL MOTORS CORP.
4. Discard the input shaft oil deflector after removal.