LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 52 (Manual Transmission - NV 3500 - Overhaul) >> Repair Instructions >> Input Shaft Bearing Retainer Assembly >> Disassembly Procedure

Disassembly Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the seal from the main drive gear bearing retainer. Pry the seal out with a small pry bar or the equivalent.
    Fig 1: Removing Oil Seal From Input Shaft Bearing Retainer
    GM761084Courtesy of GENERAL MOTORS CORP.
  2. Clean the seal bore.
scientia non olet · About LEMON Manuals