LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 52 (Manual Transmission - NV 3500 - Overhaul) >> Repair Instructions >> Input Shaft Bearing Retainer Assembly >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different variant/trim than selected.
    IMPORTANT: When installing the input shaft bearing retainer oil seal, ensure the lip of the oil seal is installed toward the installing tool.
    Fig 1: Installing Main Drive Gear Bearing Retainer Seal
    GM548122Courtesy of GENERAL MOTORS CORP.
  1. Install the oil seal into the main drive gear bearing retainer using a suitable installing tool.
  2. Ensure the seal is fully seated.
scientia non olet · About LEMON Manuals