LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Spark Plug Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the spark plug wire. Refer to Spark Plug Wire Replacement .
  2. Loosen the spark plug 1 or 2 turns.
  3. Brush or using compressed air, blow away any dirt from around the spark plug.
  4. Remove the spark plug. If removing more than one plug, place each plug in a tray marked with the corresponding cylinder.
    Fig 1: View Of Spark Plug
    GM858212Courtesy of GENERAL MOTORS CORP.