LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Intake Air Resonator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the air cleaner resonator outlet duct.
  2. Install the air cleaner resonator outlet duct to the throttle body.
    Fig 1: Air Cleaner Resonator Outlet Duct
    GM858226Courtesy of GENERAL MOTORS CORP.
  3. Align the stud on the throttle body with the screw on the clamp.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  4. Tighten the air cleaner resonator outlet duct clamp at the throttle body.

    Tighten:  Tighten the clamp to 4 N.m (35 lb in).

  5. Install the air cleaner resonator outlet duct to the MAF/IAT sensor.
    Fig 2: Intake Air Resonator
    GM858228Courtesy of GENERAL MOTORS CORP.
  6. Tighten the air cleaner resonator outlet duct clamp at the MAF/IAT sensor.

    Tighten:  Tighten the clamp to 4 N.m (35 lb in).

scientia non olet · About LEMON Manuals