LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the fuel tank. Refer to Fuel Tank Replacement (Pickup)  or Fuel Tank Replacement (Cab/Chassis - Front)  or Fuel Tank Replacement (Cab/Chassis - Rear) .
  2. Using a slight rocking motion, while pulling straight up, remove the fuel tank pressure sensor (1).
    Fig 1: Fuel Tank Pressure Sensor
    GM1312078Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals