Installation Procedure

WARNING: This page is about a different variant/trim than selected.

Install the fuel fill and vent hoses to the tank.
Tighten the fuel vent pipe hose clamp (1) at the tank.

Fig 1: Fuel Fill Pipe & Fuel Vent Pipe Hose Clamps
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.
Tighten the fuel fill pipe hose clamp (2) at the tank.
Tighten: Tighten the clamps to 2.5 N.m (22 lb in).