LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Engine Controls - 8.1L - Introduction (2 Of 2)) >> Repair Instructions >> Filler Tube Replacement (Cab/Chassis - Front) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the caps from the fuel and vent openings in the tank.
  2. Install the fuel fill pipe and vent pipe to the tank.
    NOTE: Refer to Fastener Notice in Cautions and Notices.
  3. Tighten the vent pipe clamp (1) at the tank.
    Fig 1: View Of Fuel Fill Pipe Clamp & Vent Pipe Clamp
    GM1228174Courtesy of GENERAL MOTORS CORP.
  4. Tighten the fuel fill pipe clamp (2) at the tank.

    Tighten:  Tighten the clamps to 2.5 N.m (22 lb in).

    5. Fig 2: View Of Fuel Feed And Pressure Balance Lines
    GM1228187Courtesy of GENERAL MOTORS CORP.
  5. Remove the caps from the fuel feed and EVAP pipes.
  6. If equipped with a rear auxiliary tank, connect the fuel and EVAP quick connect fittings. Refer to Quick Connect Fitting(s) Service (Metal Collar) .
scientia non olet · About LEMON Manuals