LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 37 (Engine Mechanical - 6.6L - Off Vehicle Repair Instructions (3 Of 3)) >> Off-Vehicle Repair INSTRUCTIONST (Part 3) >> Cooling Fan Pulley Installation

Cooling Fan Pulley Installation

WARNING: This page is about a different variant/trim than selected.
  1. Lubricate the camshaft position sensor O-ring with engine oil.
  2. Install the camshaft position sensor.
    Fig 1: View Of Camshaft Position Sensor
    GM1334865Courtesy of GENERAL MOTORS CORP.
    3. NOTE: Refer to FASTENER NOTICE .
  3. Install the camshaft position sensor retaining bolt.

    Tighten:  Tighten the camshaft position sensor retaining bolt to 10 N.m (89 lb in).

  4. Install the cooling fan pulley.
    Fig 2: View Of Cooling Fan Pulley
    GM1334864Courtesy of GENERAL MOTORS CORP.
  5. Install the cooling fan pulley bolts and nuts.

    Tighten:  Tighten the cooling fan pulley bolts and nuts to 41 N.m (30 lb ft).

  6. Connect the camshaft position sensor connector.
    Fig 3: View Of Camshaft Position Sensor Electrical Connector
    GM1334862Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals