Water Pump Installation

WARNING: This page is about a different variant/trim than selected.

Lubricate the water pump O-ring with engine oil.
Install the engine coolant pipe gasket.
Install the water pump seal.
Install the water pump. Be sure the water pump studs align with the coolant tube.

Fig 1: View Of Engine Coolant Pipe & Gasket
Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to FASTENER NOTICE .

Install the water pump bolts.
Tighten: Tighten the water pump bolts to 25 N.m (18 lb ft).
Install the water pump to coolant tube nuts.

Fig 2: View Of Water Pump Outlet Pipe Nuts
Courtesy of GENERAL MOTORS CORP.

Tighten: Tighten the water pump to coolant tube nuts to 25 N.m (18 lb ft).