Principle of Operation

WARNING: This page is about a different variant/trim than selected.

The Allison transmission incorporates control logic that enables the transmission to revert to a limited total hydraulic operation. The hydraulic system provides a Limp Home Mode, allowing the operator to drive the vehicle to a service location. If power is interrupted while the transmission is operating in R, REVERSE, or N, NEUTRAL, the transmission defaults to or continues NEUTRAL operations. The operator may turn off the engine and start the engine again. The shift selector provides REVERSE/NEUTRAL/DRIVE capability regardless of the range where the failure occurred. In this state, pressure control solenoid 1 (PCS1), de-energized, allows the 3rd, 5th and reverse clutch to be applied. If the selector valve is moved to the REVERSE position, main pressure is routed to the low and reverse clutch, allowing REVERSE operation. If the selector valve is moved to the DRIVE position, main pressure is routed to the 1-2-3-4 clutch, allowing THIRD range operation.