Conditions for Running the DTC
WARNING: This page is about a different variant/trim than selected.
- The system voltage is 10-18 volts.
- Power Maintain relay is ON.
- Accelerator pedal is not applied.
- Hood switch is closed.
- Vehicle is not in 4WD low.
- 14-volt Bus load is less than 1.5 kw.
- Skip impending is FALSE.
- Engine speed is below 1000 RPM.
- Not in EPTO continuous mode.
- HVAC system is not requesting engine ON.
- Engine run time is greater than 30 seconds.
- Transmission is in D4, D3 or PARK for greater than 5 seconds.
- Tow/Haul mode is not selected.
- Transmission temperature is between 21-104°C (70-219°F).
- More than 5 seconds has elapsed since the exit of the last IEO.
- PRNDL is in D4, D3 and Brake Pedal is applied or PRNDL is in PARK.
- Vehicle speed is less than 30 km/h (19 mph) then drops to 2 km/h (1 mph), or vehicle speed is greater than 30 km/h (19 mph) then drops to less than 20 km/h (12 mph).
- If IAT is less than 10°C (50°F), ECT must be above 75°C (167°F).
- If IAT is less than 15°C (59°F), ECT must be above 60°C (140°F).
- If IAT is greater than 22°C (72°F), ECT must be between 45°C (113°F) and 150°C (302°F).
- 42-Volt battery voltage is greater than 34-volt.
42-Volt battery has enough state-of-charge to sustain EIO mode for greater than 15 seconds.