Circuit Description
WARNING: This page is about a different variant/trim than selected.
Pressure control solenoid 2 (PCS2) is used to control on-coming, off-going, and holding pressure in any 1 of 5 clutches. This solenoid is referred to as a pressure proportional to current (PPC) solenoid since the output hydraulic pressure supplied by this solenoid is proportional to the controlled current command.
The transmission control module (TCM) uses information from the turbine and output speed sensors (OSS) to detect if a clutch is slipping. The clutch being controlled by PCS2 will vary, depending on the shift that was being completed.
DTC P0776 is a type A DTC.