LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure (MAP) Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install a NEW MAP sensor seal, if necessary.
    Fig 1: Installing MAP Sensor
    GM10933Courtesy of GENERAL MOTORS CORP.
  2. Install the MAP sensor.
  3. Connect the MAP sensor electrical connector (2).
    Fig 2: Connecting MAP Sensor Electrical Connector
    GM782178Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals