LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Pressure Dampener Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the upper intake manifold. Refer to Intake Manifold Replacement - Upper .
  2. Remove the fuel pressure dampener retaining clip (7).
    Fig 1: Exploded View Of Fuel Meter Body Assembly
    GM1655471Courtesy of GENERAL MOTORS CORP.
  3. Twist and pull the fuel pressure dampener (6) in order to remove the regulator from the housing using a shop towel to catch any spilled fuel.
  4. Remove and discard the dampener O-ring seal (5).
  5. Cover the fuel pressure dampener housing to prevent contamination from entering the fuel system.
scientia non olet · About LEMON Manuals