LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Controls - 4.3L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position (CKP) Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
IMPORTANT: The crankshaft position (CKP) system variation learn procedure will need to be performed whenever the CKP sensor is removed or replaced.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. If equipped, remove the engine shield bolts.
  3. Remove the engine shield.
    Fig 1: View Of Engine Protection Shield
    GM349061Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the CKP sensor electrical connector (5).
    Fig 2: View Of Oil Level Sensor Electrical Connector, CKP Electrical Connector & Battery Ground Bolt
    GM782731Courtesy of GENERAL MOTORS CORP.
  5. Remove the CKP sensor bolt.
    Fig 3: Removing CKP Sensor Bolt
    GM10938Courtesy of GENERAL MOTORS CORP.
  6. Remove the CKP sensor.
    Fig 4: View Of CKP Sensor & Bolt
    GM11485Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals