Circuit Description
WARNING: This page is about a different variant/trim than selected.
The transmission internal mode switch (IMS) is a sliding contact switch attached to the selector detent inside the transmission. The IMS is used by the transmission control module (TCM) to detect the angular position of the shift selector shaft. There are 5 internal switches in the IMS, A, B, C, P and NS. The TCM uses 4 of these switch inputs to determine the proper gear range that is selected. The fifth switch, NS, located in the IMS, is used as confirmation that the transmission is in NEUTRAL before the engine starter is engaged.
DTC P0708 is a type A DTC.