LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Manual Transmission Clutch System) >> Repair Instructions >> Release Bearing Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the manual transmission. Refer to:
  2. Remove the clutch release bearing.
    • Rotate the bearing in either direction
      Fig 1: Rotating Clutch Release Bearing
      GM71484Courtesy of GENERAL MOTORS CORP.
    • The compression spring load will push the release bearing off the end of the clutch actuator bearing.
scientia non olet · About LEMON Manuals