LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 19 (Manual Transmission - NV 4500 - Service) >> Repair Instructions >> Transmission Housing Oil Seal Replacement - Rear (2WD) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the rear propeller shaft. Refer to Propeller Shaft Replacement - One Piece or Propeller Shaft Replacement - Two Piece .
  3. If required, remove the following:
    1. The main shaft nut
    2. The prop shaft yoke washer
    3. The main shaft washer
    4. The yoke
      5. Fig 1: Removing Propeller Shaft Yoke (2WD)
      GM775218Courtesy of GENERAL MOTORS CORP.
  4. Remove the rear seal using J 6125-B  (1) and J 23129  (2).
    Fig 2: Removing Rear Oil Seal
    GM696799Courtesy of GENERAL MOTORS CORP.
scientia non olet · About LEMON Manuals