Installation Procedure

WARNING: This page is about a different variant/trim than selected.

NOTE: Refer to FASTENER NOTICE in Cautions and Notices.

Fig 1: Installing Backup Lamp Switch

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: The backup lamp switch has pre-applied thread sealant on threads.

Install backup lamp switch.
Tighten: Tighten switch to 37 N.m (27 lb ft).
Connect backup lamp switch electrical connector (3).

Fig 2: Reconnecting Backup Lamp Switch Electrical Connector
Courtesy of GENERAL MOTORS CORP.
Lower vehicle.