LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 17 (Automatic Transmission - ALLISON - Introduction (2 Of 2)) >> Repair Instructions >> Seal Replacement - Rear Propshaft >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Remove the yoke assembly from the transmission. Refer to Output Flange/Yoke Replacement .
  2. Obtain J 24171-A  and install a 90 degree hook onto the end of the slide-hammer (1). See Special Tools .
    Fig 1: Removing Rear Seal Using Slide-Hammer
    GM659319Courtesy of GENERAL MOTORS CORP.
  3. Position the 90 degree hook behind the rear face of the seal's outer case (2).
  4. Remove the rear seal using the slide-hammer.
  5. Inspect the seal bore for scratches. Remove any scratches in the seal bore using crocus cloth.
scientia non olet · About LEMON Manuals