LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 14 (Transfer Case - NVG 263-NP1 - Service & Diagnosis) >> Repair Instructions >> Transfer Case Shield Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Position the transfer case shield to the crossmember, if equipped.
    NOTE: Refer to FASTENER NOTICE in Cautions and Notices.
  2. Install the transfer case shield bolts, if equipped.
    Fig 1: Installing Transfer Case Shield & Bolts
    GM396828Courtesy of GENERAL MOTORS CORP.

    Tighten:  Tighten the bolts to 20 N.m (15 lb ft).

  3. Lower the vehicle.
scientia non olet · About LEMON Manuals