LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Transfer Case - NVG 261-NP2 - Service & Troubleshooting) >> Repair Instructions >> Transfer Case Control Lever Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Install the control lever assembly.
    Fig 1: Installing Control Lever Assembly
    GM396835Courtesy of GENERAL MOTORS CORP.
    2. NOTE: Refer to FASTENER NOTICE .
  2. Install the control lever bolts.

    Tighten:  Tighten the bolts to 12 N.m (106 lb in).

  3. Install the control lever bezel.
    Fig 2: Installing Control Lever Knob & Transfer Case Bezel
    GM396836Courtesy of GENERAL MOTORS CORP.
  4. Install the control lever bezel screws.

    Tighten:  Tighten the screws to 2 N.m (18 lb in).

  5. Install the control lever knob.
  6. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle .
  7. Install the shift control rod. Refer to Transfer Case Control Rod Replacement .
  8. Install the front propeller shaft. Refer to Propeller Shaft Replacement - Front .
  9. Install the transfer case shield, if equipped. Refer to Transfer Case Fluid Replacement .
scientia non olet · About LEMON Manuals