LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Water-in-Fuel Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different variant/trim than selected.
  1. Drain the fuel from the fuel filter. Refer to Water-in-Fuel Draining Procedure .
  2. Remove the right front wheelhouse panel. Refer to Wheelhouse Panel Replacement in Body Front End.
  3. Disconnect the fuel filter electrical connectors.
    Fig 1: View Of Fuel Filter Assembly Connectors
    GM1334874Courtesy of GENERAL MOTORS CORP.
  4. Remove the water-in-fuel sensor (3) from the fuel filter (2).
    Fig 2: Fuel Filter Adapter, Fuel Filter & Water-In-Fuel Sensor
    GM752028Courtesy of GENERAL MOTORS CORP.