LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2006 >> Silverado 1500 HD, 4WD >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Engine Controls - 6.6L - Introduction (2 Of 2)) >> Repair Instructions >> Turbocharger Vane Position Control Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different variant/trim than selected.
    Fig 1: View Of Turbocharger Vane Control Solenoid Valve & Electrical Connector
    GM1335540Courtesy of GENERAL MOTORS CORP.
  1. Install the turbocharger vane control solenoid valve to the turbocharger.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the vane control solenoid valve bracket and bolt.

    Tighten:  Tighten the bolt to 23 N.m (17 lb ft).

  3. Connect the turbocharger vane control solenoid valve electrical connector.
  4. Position the oil feed pipe to the turbocharger.
  5. Install a NEW turbocharger oil feed pipe washer and the banjo bolt.
    Fig 2: View Of Turbocharger Oil Feed Pipe Banjo Bolt
    GM1335577Courtesy of GENERAL MOTORS CORP.

    Tighten:  Tighten the bolt to 34 N.m (25 lb ft).

  6. Install the intake manifold cover. Refer to Intake Manifold Cover Replacement in Engine Mechanical - 6.6L (LLY).
  7. Perform the turbocharger learn procedure. Refer to Turbocharger Learn Procedure .
scientia non olet · About LEMON Manuals